Warning!

Disconnect the engraver from power before cleaning.

Caution!

• The surfaces of these windows, mirrors, or lenses are prone to scratching. Avoid direct pressure or contact, which can cause scratches by grinding debris into the lenses.
• The 1st and 2nd mirrors are permanently aligned within a protective housing and should not require adjustment or cleaning. The 3rd mirror and focus lens are held within the laser head’s protective shell.
• Remember to let the cleaning fluid dry before using the machine.

Tools Needed:

• Lens brush
• Laser-safe microfiber cloth/cotton swab
• Alcohol/laser-safe cleaning solution

Cleaning Frequency: daily after each use

To clean the 1^st and 2^nd mirror’s windows:

Step 1: Remove the dust and debris using the lens brush.

Step 2: Dip the cloth or cotton swab in the solution and squeeze out the excess fluid.

Step 3: Wipe the lens clean with the cloth/swab using gentle, circular motions.

To clean the 3^rd mirror lens and focus lens:

Step 1: Gently remove the laser head’s shell from the magnets holding it in place, exposing the interior of the laser head.

Step 2: Remove the dust or debris using the lens brush.  

Step 3: Dip the cloth or cotton swab in the solution and squeeze out the excess fluid.

Step 4: Wipe the lens clean with the cloth/swab using gentle, circular motions.

Step 5: Wipe the shell’s hole clean.

Step 6: Replace the shell, allowing the magnets to snap into place. 

To clean the camera:

Step 1: Remove the dust or debris using the lens brush.  

Step 2: Dip the cloth or cotton swab in the solution and squeeze out the excess fluid.

Step 3: Wipe the lens clean with the cloth/swab using gentle, circular motions.

If any permanent spots or debris appear under the camera’s glass lens, it cannot be cleaned, and you will need to replace the camera itself. Contact customer or technical support for details if this occur.